Performance of High Quality Electrostatic Powder Coating Machine
Performance of High Quality Electrostatic Powder Coating Machine
1. Smooth powder discharge, uniform powder atomization, and continuously adjustable powder feeding speed. Because the atomized particles are fine, the sprayed powder mist should be translucent.
2. The charging effect of the powder is excellent, and it has a very obvious electrostatic adsorption capacity. The powder sprayed on the workpiece is attracted by electrostatic attraction, rather than piled up. The powder sprayed on the workpiece is subjected to a certain limit of vibration or wind. It doesn't drop a lot when blowing.
3. It should show excellent powdering performance on the dead corner of the workpiece; this is also one of the most important properties of the electrostatic powder spray gun, because even a seemingly simple workpiece may have several blind spots that are difficult to spray.
4. When spraying the workpiece, it shows a good "painting effect", such as spraying a cylinder with a diameter of 50mm, only spraying one side, the back will also absorb a large amount of powder (almost completely covered), and the powder on the back is electrostatically adsorbed , can overcome the initial velocity of the powder to "turn around and fall back" and run to the workpiece; a good coating effect is also an important manifestation of the excellent performance of the spray gun.
5. High powder feeding rate is equivalent to high powder utilization rate, thus reducing the cost of production materials. Over time, it is of great significance to the users of electrostatic spraying machines.
6. Good metal powder spraying ability; because in recent years, powders with various artistic effects have appeared on the market, many of which are mixed with metal powder, called metal powder. It is suitable for metal powder spraying (many electrostatic powder spraying machines have unsatisfactory effects when spraying metal powder, or the spray gun is very hot, and it is easy to burn the gun).
7. Good secondary dusting ability. If the workpiece that has been sprayed once is accidentally reworked due to other reasons or needs to be sprayed or even two or three times on the surface of the original coating (cured), the spray gun is still required to be able to spray evenly.
8. The gun should have the ability to work continuously for a long time; there are many electrostatic powder sprayers that cannot work continuously for a long time (more than 6 hours), because the powder spray gun heats up seriously, but in fact we often need to spray continuously for a long time to meet the deadline.
9. The high-voltage static electricity is properly controlled, and it is not easy to ignite. Firing will cause breakdown points on the surface coating of the workpiece, resulting in pinholes on the surface of the finished workpiece; and at the moment of strong ignition, it will be short-circuited due to static electricity and will not be pulverized; in addition, frequent ignition will easily make people feel insecure. Affect the normal spraying operation of the sprayer. It is also very important that when the gunpowder is mixed with air and exceeds a certain concentration, the gunfire may ignite the gunpowder and even cause an explosion!

