Knowledge

How to arrange spray gun pipeline

How to arrange spray gun pipeline

 

There are a lot of people do not pay attention to the layout of the spray gun pipeline, in fact, do not pay attention to the layout of the spray gun pipeline will easily cause a series of problems, metaphorically speaking, the spray gun does not paint, spray gun does not air.

 

How to layout spray gun pipeline:

In the application process of the actual spraying system, there are many people who do not attach great importance to the spray gun pipeline. They want to take the equipment back. It looks very simple but can be used by connecting the gas pipe and pipeline.

In fact, this is not the case, if you did not pay attention to this in the process of developing the spraying system, it is easy to cause a series of problems, metaphorically speaking, the spray gun does not paint, spray gun does not react directly in the spray gun above the problem, more some are completely no reaction.

So these are basically the result of not paying attention to the pipeline of our spraying system. In the automatic spraying system, take the repeating machine as an example, it is equipped with 4 spray guns. The basic configuration is a set of oil supply 4-minute diaphragm pump and a set of 5-gallon stirrer.

Here, it is noted that whether the gas road or oil road is the best supervisor a little bigger, so as to ensure that the oil volume or gas volume is enough. The oil route is relatively simple. The first spray gun is in charge, and then the oil is returned to the second spray gun, and so on, and then the oil is returned to the paint barrel.

Trachea is slightly more complicated, but remember don't go wrong, fire needle must not and atomization strung together, are on the spray gun cyl.ul holes don't skewer and spray CAP, FAN, or you'll spray gun can't open the case, the main reason is that atomization gas consumed too much, can make the shot and the pressure of the needle volume reduction, spray gun can't open the occur thereby. Therefore, it is best to divide into two supervisors or three supervisors (with FAN imported spray gun). In this way, each gas path is independent and easy to control.

In addition, it is emphasized that the inlet solenoid valve is advanced and then the pressure regulating valve is the last inlet spray gun. This order should not be mistaken. There are mistakes in the actual process, mainly because the solenoid valve also has a certain role in decompression. Air pressure to the gun is not very accurate, so the atomization is very well tuned.

 

You Might Also Like

Send Inquiry